Toshiba P47LSB User Manual - Page 19

Effective range • Point the remote control at remote sensor on LCD monitor. About the remote control • Do not drop, shake or bump. • Do not wet, do not place on wet materials. • Do not dismantle. • Do not place in locations exposed to high temperature or high humidity levels. Remote control hand unit emits Infra-Red light, modulated by the internal codes. Do not try to look into the light even it cannot be seen. The receiver is located at the power indicator area, with operation angle and distance shown in picture. Note: 1. Do not disassemble remote control. 2. Do not drop, give shock to it. 3. Avoid any water getting into remote control. 4. Avoid high temperature outdoor use. +- 10 degrees left to right WIRELESS REMOTE CONTROL OPERATION Turn On the power Finish connecting all displays before turning on the power. The hard switch is located at the rear of the display, and is a full on-off switch. The 'Power' push button on the remote control is a soft-on-off switch. Be sure to turn on the hard switch first to operate. Now depress remote control Power button to place display in STAND-BY or ON mode. Key button on the remote control (* indicates that the side key switch on the display also works) * POWER: * MENU: * up: * down: * < left: * > right: * ENTER: * EXIT: AUTO: SOURCE: PIP: SWITCH: selection of ON or STAND-BY, lamp and driver power supply are reduced. to enter 1st MENU page Main Menu Item selection Main Menu Item selection Sub Menu selection or value change Sub Menu selection or value change Selected value / Menu, ENTER Exit from Selected Menu Automatic configuration/Centering Input selection Picture in Picture selection Picture-in-picture image switch These 8 functions (*) may also be controlled by buttons located on the side of the product as indicated in picture. The additional 3 functions such as Auto, PIP and Switch are controlled only by the hand remote control. Refer to the next page enlarged keys too. 19