Toshiba Satellite A300 Maintenance Manual - Page 159
Installing the display assembly, of hinge, display assembly, hinges, screws, display mask, mask seal
View all Toshiba Satellite A300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 159 highlights
Replacement Procedures Installing the display assembly The following describes the procedure for installing the display assembly (See Figure 4-13 to 4-17). 1. Inserting the pole of hinge to the hole of hinge assembly, set the display assembly on the base assembly. 2. Secure the hinges with the following screws secure the display mask with the following screws and stick the mask seal on them. • M2.5×5.0B FLAT BIND screw x2 (Locktight) NOTE: Be sure to apply the locktight to the screws instructed in the figure above. 3. Connect the LCD harness to the connector on the system board. 4. Arrange the wireless antenna cables along the guide (front) and secure them with guide. 5. Pass the cables to the back of computer through the slot. 6. Arrange the wireless LAN antenna along the guide and contact with the connector. 7. Install the LAN board and cover ASSY of the system. Satellite A300 Maintenance Manual(960-Q08) 4-28