Xerox 2218 Systems Administration Guide - Page 34
Print Protocol, public, Add Printer Wizard, WorkCentre 4118 / FaxCentre 2218, Printer Name, Test Print
UPC - 095205233940
View all Xerox 2218 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
Print Driver Installation for Networked Printers If the network printer settings are not automatically detected, click on the [Custom] button to setup the network printer port settings. It is recommended that you select [RAW] as the Print Protocol. If you prefer to use LPR: Select [LPR] as the Print Protocol. Enter lp (in lower case) in the [LPR print queue] field. Uncheck the box labelled [LPR Byte Counting Enabled]. Check the box labelled [SNMP Status Enabled]. The [Community Name] should normally be set to public (unless you have configured the device to have a custom SNMP community name) and the [SNMP Device Index] should be set to 1. Select [OK]. 4 ¾ The Add Printer Wizard will then request that you select the driver to be used for this printer. Insert the CD containing the WorkCentre 4118 / FaxCentre 2218 drivers and select [Have Disk]. Browse to the required Windows 2000 driver on the CD and select [OK]. NOTE: The driver will be found on the appropriate PCL or PS CD, in the Drivers>Print>ADDPrint folder. You will need to select the required language and operating system. The driver is identified by the file extension .inf. Select [Next], and select [Next] again and the WorkCentre 4118 / FaxCentre 2218 driver will be loaded onto the workstation. Enter the Printer Name and select [Next]. 5 ¾ If you wish to share the printer over the network select [Shared]. You may also wish to install printer drivers for other operating systems that will access the printer. A dialog box displays with a message regarding the printing of a test page. Select [Finish] to accept the Yes choice. 6 ¾ Continue with Test Print, see Test Print 8-16. Page 4-6 Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide