Xerox 2218 Systems Administration Guide - Page 71
Snmp, Con Snmp
UPC - 095205233940
View all Xerox 2218 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Network Installation Using CentreWare Internet Services SNMP Use these instructions to configure the Simple Network Management Protocol (SNMP) using CentreWare Internet Services. Configure SNMP To configure SNMP, perform these steps: 1 ¾ Open CentreWare Internet Services (see Open CentreWare Internet Services (see Accessing CentreWare Internet Services on page 7-4). 2 ¾ At the CentreWare Internet Services Home Page for the WorkCentre 4118 / FaxCentre 2218, select the [Properties] link. 3 ¾ Select the plus symbol [+] to the left of the Connectivity folder in the Properties frame, and then select the [+] symbol to the left of the Protocols folder. 4 ¾ Select [SNMP] and check the Protocol Configuration details are correct. If any of the details are incorrect then enter the correct information. 5 ¾ Make the following selections and settings in the SNMP Properties section of the frame: Select the checkbox to enable the SNMP Protocol. Click the [Edit] button to configure SNMP. You can change the GET and SET Community Names. NOTE: Changes made to the GET and SET Community Names will require corresponding changes for each application that uses the protocol. You can set the Default TRAP Community Name. NOTE: This specifies the default trap community name for all traps generated by the machine and can be overridden by the trap community name specified for each TRAP destination address. It may not have the same trap community name as that specified for another address. You can Enable Authentication Failure Generic Traps to generate a trap for every SNMP request received by the machine that contains an invalid community name. ¾ Click the [Apply] button to implement any changes and return to the first screen. Xerox WorkCentre 4118 and FaxCentre 2218 System Administration Guide Page 7-11