Xerox 6180N DocuSP Common Controller System Guide - Page 16
SNMP gateway configuration
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Gateway and Network Configuration SNMP gateway configuration SNMP displays the status of network devices. Using the SNMP tab in Gateways, the administrator can select among a number of features and settings for SNMP. NOTE: SNMP requires a standard license. The System Administrator must enable SNMP in License Manager. Xerox recommends the following thirdparty SNMP software managers: • IBM Network Printer Manager (NT) • TNG Unicenter (NT) • HP OpenView (UNIX, NT) • Xerox CentreWare (UNIX, NT) NOTE: The SNMP manager (for example, HP OpenView) may have a number of requests into DocuSP for information. The requested information may not be among the supported data sets on DocuSP. When this occurs, the SNMP client/ manager displays no value...etc. NOTE: You can have more than one SNMP manager running at the same time. Additional features supported in SNMP SNMP support for the following features are product dependent: • The ability to SET attributes. • The ability to localize text and units of measure. • The ability to support a number of MIBs related to finishing and printing. • The ability to perform meter reading automatically. The following table specifies which Xerox products have these SNMP supported features: Table 0-1. SNMP Supported Features by Product Feature 61XX EPS 1XX DC2000/ 6000/etc DP/DT DT100/ 75/90 iGen 120 Ability to SET Attributes Y Y Y Y N Y Localization of Attributes Y Y Y Y N N Finishing Capability for a Y N Device MIB Y N N Y 1-2 System Guide