Xerox 6180N DocuSP Common Controller System Guide - Page 89
Backup and restore of tray settings
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
Finishing Once the print job has been sent, the user cannot change media sources. However, the XPIF job ticket media source to tray mapping can be overridden for all the trays on the queue. There are two ways in which an operator can specify the PCL tray to media mapping: 1. XPIF job ticket. This ticket must be pre-appended to the job. 2. IPP Attributes. The information in the XPIF ticket and IPP attributes become part of the job attributes sent to the system. Backup and restore of tray settings The saved mappings can be copied to a different system by using the DocuSP Configuration Backup/Restore utility from the System Menu. DocuSP software allows the selection of individual components to back up and restore. If a saved mapping contains more trays than the new system has, the user will be notified but the operation will continue with only the supported trays programmed. If the mapping contains fewer trays than those on the new system, the system will use only those programmed. In either case, the operator will be notified but the operation will continue. NOTE: If the saved mapping contains programming for stocks that physically cannot be programmed on the new system, then this is an error and the operation will not continue. NOTE: A mapping created on a monochrome or highlight color system can only be restored on another monochrome or highlight color system. Likewise a mapping created for a color system can only be restored on a full color system. NOTE: If a mapping requires LCDS stocks MAIN, AUX or AUTO on a system that does support LCDS, then the operation will not continue. System Guide 5-5