Yamaha CVP-405 Owner's Manual - Page 207

Appendix 110 6 Installing E. 1 Remove the plastic cover from D. D 2 Untie and straighten out the bundled cord attached to the bottom of E. E D E 3 Pass the pedal cord between E and D. 4 Make sure that E lays flat, with no gap between itself and the floor, then affix the E using two screws. 7 Connect the pedal cord. 1 Insert the pedal cord plug into the pedal connector. Insert the plug with the arrow-printed side facing front (toward the keyboard side). If the plug will not go in easily, do not force it. Double-check the orientation of the plug, then try again. Correct Incorrect 2 Align the pedal cord into the groove on D, and install the plastic cover onto the groove. Be careful not to insert the cover's attachment strip between the groove wall and the leg. 8 Set the voltage selector and connect the power cord. 240 220 (the bottom of the right side 127 as seen from the front) Voltage Selector Before connecting the AC power cord, check the setting of the voltage selector which is provided in some areas. To set the selector for 110V, 127V, 220V or 240V main voltages, use a "minus" screwdriver to rotate the selector dial so that the correct voltage for your region appears next to the pointer on the panel. The voltage selector is set at 240V when the unit is initially shipped. After the proper voltage has been selected, connect the AC power cord to the AC INLET and an AC wall outlet. A plug adaptor may be also provided in some areas to match the pin configuration of the AC wall outlets in your area. WARNING An improper voltage setting can cause serious damage to the instrument or result in improper operation. 9 Set the adjuster. Rotate the adjuster until it comes in firm contact with the floor surface. ■ After completing the assembly, please check the following. • Are there any parts left over? → Review the assembly procedure and correct any errors. • Is the instrument clear of doors and other movable fixtures? → Move the instrument to an appropriate location. • Does the instrument make a rattling noise when you shake it? → Tighten all screws. • Does the pedal box rattle or give way when you step on the pedals? → Turn the adjuster so that it is set firmly against the floor. • Are the pedal and power cords inserted securely into the sockets? → Check the connection. • If the main unit creaks or is otherwise unsteady when you play on the keyboard, refer to the assembly diagrams and retighten all screws. When moving the instrument after assembly, always hold the bottom of the main unit. CAUTION Do not hold the key cover or top portion. Improper handling can result in damage to the instrument or personal injury. Top portion Key cover Do not hold here. Hold here. Do not hold here. CVP-405/403/401 Owner's Manual 207