Yamaha CVP-405 Owner's Manual - Page 208

CVP-403: Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor- dance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of Have a Phillips-head (+) screwdriver ready. each unit. • To disassemble, reverse the assembly sequence given below. 1 Open the package, take out marked "C" in the illustration, take out the styrofoam pads, and place the unit A on top of the pads. Position the pads so that they will protect the headphone jack located underneath the front left corner. Phones jacks A Styrofoam pads To prevent the key cover from accidentally opening during assembly, press down on the key cover, making sure that the sheet (shown) remain in place. B 3 Attach B. Depending on the model of digital piano you purchased, the surface color of one side of the rear panel may be different from the other side. In this case, position the rear panel so that the side of the surface color similar to the side panel (left) and the side panel (right) faces the player. 1 Place the lower side of B on each foot of D and E, then attach the upper side to D and E. 2 Attach the top of B to D and E by finger-tightening the thin screws (4 ✕ 12mm). 3 While pushing the lower part of D and E from outside, secure the bottom ends of B using two tapping screws (4 ✕ 20mm). 4 Insert the other two tapping screws (4 ✕ 20mm) into the other two screw holes to secure B. 5 Securely tighten the screws on the top of B that were attached in Step 3-2. 1 E 25 B 3 4 D 3 Bundled pedal cord inside C D E Assembly Parts AC power cord 6 ✕ 25 mm long screws ✕ 4 6 ✕ 16 mm short screws ✕ 4 4 ✕ 20 mm tapping screws ✕ 4 4 ✕ 12 mm thin screws ✕ 2 Cord holders ✕ 2 2 Attach C to D and E. 1 Untie and straighten out the bundled cord attached to the bottom of the C. Don't discard the vinyl tie, you'll need it later in step 6. D 4 Mount A. CAUTION • Fingers can become pinched between A and C/D/E, be extra careful so as not to drop A. • Do not hold the keyboard in any position other than the position shown in the illustration. Be sure to place your hands at least 10 cm from either end of A when positioning it. A At least 10 cm E C 2 Use the four 6 ✕ 25 mm long screws to attach C. First attach one side panel, then attach the other side panel. 208 CVP-405/403/401 Owner's Manual Appendix