Yamaha CVP-405 Owner's Manual - Page 210

CVP-401: Keyboard Stand Assembly CAUTION • Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor- dance with the sequence given below. • Assembly should be carried out by at least two persons. • Be sure to use the correct screw size, as indicated below. Use of incorrect screws can cause damage. • Be sure to tighten up all screws upon completing assembly of each unit. Have a Phillips-head (+) screwdriver ready. • To disassemble, reverse the assembly sequence given below. 1 Open the package, take out marked "C" in the illustration, take out the styrofoam pads, and place the unit A on top of the pads. Remove all parts from the box. Confirm that all parts shown in the illustration are provided. A Styrofoam pads B Bundled pedal cord inside C 3 Attach B. Depending on the model of digital piano you purchased, the surface color of one side of the rear panel may be different from the other side. In this case, position the rear panel so that the side of the surface color similar to the side panel (left) and the side panel (right) faces the player. 1 Place the lower side of B on each foot of D and E, then attach the upper side to D and E. 2 Attach the top of B to D and E by finger-tightening the thin screws (4 ✕ 12mm). 3 While pushing the lower part of D and E from outside, secure the bottom ends of B using two tapping screws (4 ✕ 20mm). 4 Insert the other two tapping screws (4 ✕ 20mm) into the other two screw holes to secure B. 5 Securely tighten the screws on the top of B that were attached in Step 3-2. E 25 B 1 3 4 3D 4 Securely tighten the screws on C that were attached in Step 2-3. R L L D E Assembly Parts 6 ✕ 20 mm long screws ✕ 4 AC power cord 6 ✕ 16 mm short screws ✕ 4 4 x 20 mm tapping screws ✕ 4 4 ✕ 12 mm thin screws ✕ 2 Cord holders ✕ 2 2 Attach (finger-tighten) C to D and E. E 2 D C 3 1 1 Untie and straighten out the bundled pedal cord. Don't discard the vinyl tie, you'll need it later in step 7. 2 Align D and E with each end of C. 3 Attach D and E to C by finger-tightening the long screws (6 ✕ 20 mm). 210 CVP-405/403/401 Owner's Manual C Tighten the screw. 5 Mount A. CAUTION • Fingers can become pinched between the unit A and the rear or side panels, be extra careful so as not to drop the A. • Do not hold the keyboard in any position other than the position shown in the illustration. Be sure to place your hands at least 10 cm from either end of A when positioning it. A E At least 10 cm B D Appendix