Yamaha DTX900 Owner's Manual - Page 140

Reference Sampling Mode [SAMPLING] E [SF1] AUDITION You can hear the selected User Voice by holding this button. F [SF2] LP=ST When the menu indication here is "LP=ST," the Start (Start Point) and the Loop (Loop Start Point) will share the same address, meaning that both of them will be changed simultaneously, even if just one of them is changed. Pressing the [SF2] button in this condition changes the menu from "LP=ST" to "LP≠ST." When the menu indication here is "LP≠ST," the Start (Start Point) and the Loop (Loop Start Point) can be changed independently. When pressing the [SF2] button in this condition, the address value of the Start will be copied to that of the Loop, with the result that both of them share the same address value. The menu indication also changes from "LP≠ST" to "LP=ST." G [SF3] ZOOM - H [SF4] ZOOM + Press these buttons to zoom in and out of the waveform display of the User Voice in the display. I [SF5] SET END > Pressing this button calls up the display for determining the End Point, from which you can set the tempo, beat, and measure for the audio data included in the User Voice. For details, see page 141. J [SF6] NUM You can use the [SF1] - [SF5] and [F1] - [F6] buttons as number buttons by pressing the [SF6] NUM button. For details, see page 14. K [F5] DISPLAY This menu item appears only when zooming in on the waveform display beyond a certain point (usually several presses of the ZOOM + button). When you zoom beyond this point, the display changes to a split screen, with the left side showing the Start Point area and the right side showing the End Point area. Pressing the [F5] DISPLAY in this condition alternates between the split screen display and a display showing either the Start Point area, Loop Point area, or the End Point area (depending on which parameter has been selected). 5 If necessary, set the End Point as desired by using the display called up via the [SF5] SET END button. From the display called up via the [SF5] SET END button, set the related parameters to determine the End Point. After setting the parameters, press the [SF1] AUDITION button to hear the result of your settings. If you are satisfied with the result, press the [F6] OK button to return to the original display. For details, see page 141. 6 From the [F3] TRIM display, press the [SF1] AUDITION button to hear the result of the settings. If you are not satisfied with the result, repeat Steps 3 - 5 as desired. 7 Save the created User Voice data to a USB storage device. For detailed instructions on saving, see pages 55 and 114. NOTICE • The User Voice data resides temporarily in DIMM (pages 76 and 147). Any data in DIMM will be lost when turning the power off. You should always save any data residing in DIMM to a USB storage device before turning off the power. 4 Specify the playback-only portion of the audio data in the User Voice by using the data dial, [INC/YES] and [DEC/NO] but- tons. In this step, you can set the Start Point, Loop Point and the End Point-all of which determine how much of the audio will play back and how it will play back. Use the ZOOM +/controls (as well as the AUDITION control) to adjust how much of the waveform is displayed, making it easier to specify the playback-only portion. 140 DTX900 Owner's Manual