Home » ZyXEL Manuals » Networking » ZyXEL NBG-417N » Manual Viewer

ZyXEL NBG-417N User Guide - Page 164

Disable, Router, Access Point, Advanced Suggestion, my Internet connection is not available anymore.

Get ZyXEL NBG-417N PDF manuals and user guides

Add to My Manuals
Save this manual to your list of manuals

Page 164 highlights

Chapter 23 Troubleshooting 2 Make sure you entered your ISP account information correctly in the wizard. These fields are casesensitive, so make sure [Caps Lock] is not on. 3 If you are trying to access the Internet wirelessly, make sure the wireless settings in the wireless client are the same as the settings in the AP. • Go to Network > Wireless LAN > General > WDS and check if the NBG-417N is set to bridge mode. Select Disable and try to connect to the Internet again. 4 Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again. 5 Go to Maintenance > Sys OP Mode > General. Check your System Operation Mode setting. • Select Router if your device routes traffic between a local network and another network such as the Internet. • Select Access Point if your device bridges traffic between clients on the same network. 6 If the problem continues, contact your ISP. I cannot access the Internet anymore. I had access to the Internet (with the NBG-417N), but my Internet connection is not available anymore. 1 Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick Start Guide and Section 1.5 on page 16. 2 Reboot the NBG-417N. 3 If the problem continues, contact your ISP. The Internet connection is slow or intermittent. 1 There might be a lot of traffic on the network. Look at the LEDs, and check Section 1.5 on page 16. If the NBG-417N is sending or receiving a lot of information, try closing some programs that use the Internet, especially peer-to-peer applications. 2 Check the signal strength. If the signal strength is low, try moving the NBG-417N closer to the AP if possible, and look around to see if there are any devices that might be interfering with the wireless network (for example, microwaves, other wireless networks, and so on). 3 Reboot the NBG-417N. 4 If the problem continues, contact the network administrator or vendor, or try one of the advanced suggestions. Advanced Suggestion • Check the settings for QoS. If it is disabled, you might consider activating it. 164 NBG-417N User's Guide

Section	Page
NBG-417N	1
Table of Contents	5
User’s Guide	13
Getting to Know Your NBG-417N	15
1.1 Overview	15
1.2 Applications	15
1.3 Ways to Manage the NBG-417N	16
1.4 Good Habits for Managing the NBG-417N	16
1.5 LEDs	16
1.6 The WPS Button	17
1.7 Wall Mounting	18
Introducing the Web Configurator	19
2.1 Overview	19
2.2 Accessing the Web Configurator	19
2.3 Resetting the NBG-417N	21
2.3.1 Procedure to Use the Reset Button	21
2.4 Navigating the Web Configurator	21
2.5 Status Screen (Router Mode)	21
2.5.1 Navigation Panel	24
2.5.2 Summary: DHCP Table	25
2.5.3 Summary: Packet Statistics	26
2.5.4 Summary: WLAN Station Status	27
Connection Wizard	29
3.1 Wizard Setup	29
3.2 Connection Wizard: STEP 1: System Information	30
3.2.1 System Name	30
3.2.2 Domain Name	30
3.3 Connection Wizard: STEP 2: Wireless LAN	31
3.3.1 Extend (WPA-PSK or WPA2-PSK) Security	32
3.4 Connection Wizard: STEP 3: Internet Configuration	33
3.4.1 Ethernet Connection	34
3.4.2 PPPoE Connection	34
3.4.3 PPTP Connection	35
3.4.4 Your IP Address	36
3.4.5 WAN IP Address Assignment	37
3.4.6 IP Address and Subnet Mask	37
3.4.7 DNS Server Address Assignment	38
3.4.8 WAN IP and DNS Server Address Assignment	38
3.4.9 WAN MAC Address	39
3.5 Connection Wizard Complete	41
AP Mode	43
4.1 Overview	43
4.2 Setting your NBG-417N to AP Mode	43
4.3 Status Screen (AP Mode)	44
4.3.1 Navigation Panel	46
4.4 Configuring Your Settings	47
4.4.1 LAN Settings	47
4.4.2 WLAN and Maintenance Settings	48
4.5 Logging in to the Web Configurator in AP Mode	48
Tutorials	49
5.1 Overview	49
5.2 How to Connect to the Internet from an AP	49
5.2.1 Configure Wireless Security Using WPS on both your NBG-417N and Wireless Client	49
5.2.2 Enable and Configure Wireless Security without WPS on your NBG- 417N	53
5.3 Bandwidth Management for your Network	56
5.3.1 Configuring Bandwidth Management by Application	56
5.3.2 Configuring Bandwidth Management by Custom Application	57
5.3.3 Configuring Bandwidth Allocation by IP or IP Range	58
Technical Reference	61
Wireless LAN	63
6.1 Overview	63
6.2 What You Can Do	63
6.3 What You Should Know	64
6.3.1 Wireless Security Overview	64
6.4 General Wireless LAN Screen	66
6.4.1 No Security	68
6.4.2 WEP Encryption	68
6.4.3 WPA-PSK/WPA2-PSK	70
6.5 MAC Filter	71
6.6 Wireless LAN Advanced Screen	72
6.7 Quality of Service (QoS) Screen	73
6.7.1 Application Priority Configuration	75
6.8 WPS Screen	77
6.9 WPS Station Screen	77
6.10 Scheduling Screen	79
6.11 WDS Screen	79
6.11.1 Security Mode: Static WEP	81
6.11.2 Security Mode: WPA-PSK/WPA2-PSK	82
WAN	85
7.1 Overview	85
7.2 What You Can Do	85
7.3 What You Need To Know	85
7.3.1 Configuring Your Internet Connection	86
7.3.2 Multicast	87
7.3.3 NetBIOS over TCP/IP	87
7.3.4 Auto-Bridge	88
7.4 Internet Connection	88
7.4.1 Ethernet Encapsulation	88
7.4.2 PPPoE Encapsulation	90
7.4.3 PPTP Encapsulation	92
7.5 Advanced WAN Screen	94
LAN	97
8.1 Overview	97
8.2 What You Can Do	97
8.3 What You Need To Know	98
8.3.1 IP Pool Setup	98
8.3.2 LAN TCP/IP	98
8.4 LAN IP Screen	99
DHCP Server	101
9.1 Overview	101
9.2 What You Can Do	101
9.3 What You Need To Know	101
9.4 General Screen	102
9.5 Advanced Screen	102
9.6 Client List Screen	104
Network Address Translation (NAT)	107
10.1 Overview	107
10.2 What You Can Do	107
10.3 General NAT Screen	108
10.4 NAT Application Screen	108
10.5 NAT Advanced Screen	111
10.5.1 Trigger Port Forwarding Example	112
10.5.2 Two Points To Remember About Trigger Ports	112
Dynamic DNS	115
11.1 Overview	115
11.2 Dynamic DNS Screen	115
Firewall	117
12.1 Overview	117
12.2 What You Can Do	117
12.3 What You Need To Know	118
12.3.1 About the NBG-417N Firewall	118
12.4 General Firewall Screen	118
12.5 Services Screen	119
Content Filtering	121
13.1 Overview	121
13.2 What You Can Do	121
13.3 What You Need To Know	121
13.3.1 Content Filtering Profiles	121
13.4 Filter Screen	122
13.5 Technical Reference	123
13.5.1 Customizing Keyword Blocking URL Checking	123
Static Route	125
14.1 Overview	125
14.2 What You Can Do	125
14.3 IP Static Route Screen	126
14.3.1 Static Route Setup Screen	127
Bandwidth Management	128
15.1 Overview	128
15.2 What You Can Do	128
15.3 What You Need To Know	129
15.4 General Configuration	129
15.5 Advanced Configuration	130
15.5.1 Priority Levels	132
15.5.2 User Defined Service Rule Configuration	133
15.5.3 Predefined Bandwidth Management Services	134
15.5.4 Services and Port Numbers	134
Remote Management	135
16.1 Overview	135
16.2 What You Can Do	135
16.3 What You Need To Know	135
16.3.1 Remote Management Limitations	136
16.3.2 Remote Management and NAT	136
16.3.3 System Timeout	136
16.4 WWW Screen	136
Universal Plug-and-Play (UPnP)	138
17.1 Overview	138
17.2 What You Can Do	138
17.3 What You Need to Know	138
17.4 UPnP Screen	139
17.5 Technical Reference	140
17.5.1 Using UPnP in Windows XP Example	140
17.5.2 Web Configurator Easy Access	142
System	145
18.1 Overview	145
18.2 What You Can Do	145
18.3 System General Screen	145
18.4 Time Setting Screen	147
Logs	149
19.1 Overview	149
19.2 What You Can Do	149
19.3 What You Need to Know	149
19.4 View Log Screen	149
Tools	151
20.1 Overview	151
20.2 What You Can Do	151
20.3 Firmware Upload Screen	151
20.4 Configuration Screen	153
20.4.1 Backup Configuration	153
20.4.2 Restore Configuration	153
20.4.3 Back to Factory Defaults	154
20.5 Restart Screen	155
Sys OP Mode	156
21.1 Overview	156
21.2 What You Can Do	156
21.3 What You Need to Know	156
21.4 General Screen	157
Language	159
22.1 Language Screen	159
Troubleshooting	161
23.1 Power, Hardware Connections, and LEDs	161
23.2 NBG-417N Access and Login	162
23.3 Internet Access	163
23.4 Resetting the NBG-417N to Its Factory Defaults	165
23.5 Wireless Router/AP Troubleshooting	165
Product Specifications	167
IP Addresses and Subnetting	171
Pop-up Windows, JavaScripts and Java Permissions	181
Setting Up Your Computer’s IP Address	193
Wireless LANs	221
Services	235
Legal Information	239

Match case Limit results 1 per page

Chapter 23 Troubleshooting

NBG-417N User’s Guide

164

Make sure you entered your ISP account information correctly in the wizard. These fields are case-

sensitive, so make sure [Caps Lock] is not on.

If you are trying to access the Internet wirelessly, make sure the wireless settings in the wireless

client are the same as the settings in the AP.

•

Go to Network > Wireless LAN > General > WDS and check if the NBG-417N is set to bridge

mode. Select

Disable

and try to connect to the Internet again.

Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again.

Go to Maintenance > Sys OP Mode > General. Check your System Operation Mode setting.

• Select

Router

if your device routes traffic between a local network and another network such

as the Internet.

• Select

Access Point

if your device bridges traffic between clients on the same network.

If the problem continues, contact your ISP.

I cannot access the Internet anymore. I had access to the Internet (with the NBG-417N), but

my Internet connection is not available anymore.

Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick

Start Guide and

Section 1.5 on page 16

Reboot the NBG-417N.

If the problem continues, contact your ISP.

The Internet connection is slow or intermittent.

There might be a lot of traffic on the network. Look at the LEDs, and check

Section 1.5 on page 16

If the NBG-417N is sending or receiving a lot of information, try closing some programs that use

the Internet, especially peer-to-peer applications.

Check the signal strength. If the signal strength is low, try moving the NBG-417N closer to the AP if

possible, and look around to see if there are any devices that might be interfering with the wireless

network (for example, microwaves, other wireless networks, and so on).

Reboot the NBG-417N.

If the problem continues, contact the network administrator or vendor, or try one of the advanced

suggestions.

Advanced Suggestion

•

Check the settings for QoS. If it is disabled, you might consider activating it.