1996 Chevrolet Monte Carlo Owner's Manual - Page 120
1996 Chevrolet Monte Carlo Manual
Page 120 highlights
P.SCAN: Press both SEEK arrows and PSCAN will appear on the display. Use PSCAN to listen to each or SEEK: Press the forward or reverse arrow to go to the your preset stations fora few seconds.The radio will go to next higher or lower station. the first preset station, stopfor a few seconds, thengo on PUSHBUTTONS: The four numbered pushbuttons let to the next preset station(FMl and FM2). (fa preset I you return toyour favorite stations.You can set up to station has weak reception, will not stop.) Press either it 21 stations (seven M , seven FM1, and seven FM2 A ). SEEK arrow, the upper knob or preset to stop scanning. a 1. Press AM-FM to select theband. Setting theTone TUNE: Turn the lower knob to choose radio stations. 2. Find the station you want by using TUNE or SEER. 3. Press SET until the word SET appears on the display. 4. Press and releaseone of the four numbered buttons, within five seconds. BASS: Slide the lever up or down to increase or decrease bass. The middle position is a detent. TREB: Slide the lever up down to increase or decrease or treble. The middle position is a detent. If a station is weak or noisy, you may want to decrease the treble. Adjusting theSpeakers BAL: Turn the control behind the upper knobmove to . the sound to the left or right speakers. The middle position isa detent and balances the speakers. FADE: Turn the control behind the lower knob to move the sound to the front or rear speakers. The middle position isa detent and balances the speakers. 5. Whenever you press that numbered button, the station you set will return. In addition to the four stations set as above, three up to additional stationsmay be preset on each band by pressing two adjoining buttons at the same time. Just: 1. Tune in the desired station. 2. Press SET. 3. Press any two adjoining pushbuttons at the same time (.withinfive seconds). 4. Whenever you press the same buttons, the station you set will return. 3-8