2015 Chrysler 200 Owner Manual - Page 221

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 219 ParkSense® can be active only when the shift lever/gear selector is in REVERSE. If ParkSense® is enabled at this shift lever/gear selector position, the system will remain active until the vehicle speed is increased to approximately 7 mph (11 km/h) or above. When in REVERSE and above the system's operating speed, a warning will appear within the Electronic Vehicle Information Center (EVIC) or Driver Information Display (DID) indicating the vehicle speed is too fast. The system will become active again if the vehicle speed is decreased to speeds less than approximately 6 mph (9 km/h). ParkSense® Warning Display The ParkSense® Warning screen will only be displayed if Sound and Display is selected from the Customer Programmable Features section of the Uconnect® System. Refer to ЉUconnect® Settings" in "Understanding Your Instrument Panel" for further information. 3 The ParkSense® Warning screen is located within the EVIC/DID. It provides visual warnings to indicate the distance between the rear fascia/bumper and the detected obstacle. Refer to "Electronic Vehicle Information ParkSense® Sensors Center (EVIC) or Driver Information Display (DID)" for The four ParkSense® sensors, located in the rear fascia/ further information. bumper, monitor the area behind the vehicle that is ParkSense® Display within the sensors' field of view. The sensors can detect obstacles from approximately 12 in (30 cm) up to 79 in When the vehicle is in REVERSE, the EVIC/DID will (200 cm) from the rear fascia/bumper in the horizontal display the park assist ready system status. direction, depending on the location, type and orientation of the obstacle.