2015 Chrysler 200 Owner Manual - Page 441

STARTING AND OPERATING 439 Cycle the ignition switch to the START position and release when the engine starts. If the engine fails to start within 10 seconds, cycle the ignition switch to the LOCK/OFF position, wait 10 to 15 seconds, then repeat the "Normal Starting" procedure. Tip Start Feature Extended Park Starting NOTE: Extended Park condition occurs when the vehicle has not been started or driven for at least 35 days. 1. Install a battery charger or jumper cables to the battery to ensure a full battery charge during the crank cycle. Cycle the ignition switch to START position and release it 2. Cycle the ignition in the START position and release it when the engine starts. as soon as the starter engages. The starter motor will continue to run, but will automatically disengage itself 3. If the engine fails to start within ten seconds, cycle the when the engine is running. If the engine fails to start, the ignition to the STOP (OFF/LOCK) position, wait five starter will disengage automatically in 10 seconds. If this seconds to allow the starter to cool, then repeat the occurs, cycle the ignition switch to the LOCK position, Extended Park Starting procedure. wait 10 to 15 seconds, then repeat the "Normal Starting" 4. If the engine fails to start after eight attempts, allow procedure. the starter to cool for at least 10 minutes, then repeat Extreme Cold Weather (Below -20°F Or −29°C) the procedure. To ensure reliable starting at these temperatures, use of an externally powered electric engine block heater (available from your authorized dealer) is recommended. 5