2015 Chrysler 200 Owner Manual - Page 551

WHAT TO DO IN EMERGENCIES 549 NOTE: If the Mode Select Knob (5) is on Air Mode and the pump is operating, air will dispense from the Air Pump Hose (7) only, not the Sealant Hose (6). latch pillar (recommended pressure). Check the tire pressure by looking at the Pressure Gauge (3). If the tire does not inflate to at least 26 psi (1.8 Bar) If the sealant (white fluid) does flow through the pressure within 15 minutes: Sealant Hose (6): • The tire is too badly damaged. Do not attempt to drive 1. Continue to operate the pump until sealant is no the vehicle further. Call for assistance. longer flowing through hose (typically takes 30 - 70 NOTE: If the tire becomes over-inflated, press the Deflaseconds). As the sealant flows through the Sealant tion Button to reduce the tire pressure to the recomHose (6), the Pressure Gauge (3) can read as high as 70 mended inflation pressure before continuing. psi (4.8 Bar). The Pressure Gauge (3) will decrease quickly from approximately 70 psi (4.8 Bar) to the If the tire inflates to the recommended pressure or is at actual tire pressure when the Sealant Bottle (1) is least 26 psi (1.8 Bar) pressure within 15 minutes: empty. 1. Press the Power Button (4) to turn off the Tire Service 2. The pump will start to inject air into the tire immediKit. ately after the Sealant Bottle (1) is empty. Continue to 2. Remove the Speed Limit sticker from the top of the operate the pump and inflate the tire to the pressure Sealant Bottle (1) and place the sticker on the instruindicated on the tire pressure label on the driver-side ment panel. 6