2015 Chrysler 200 Owner Manual - Page 32

30 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE NOTE NOTE: To avoid unintentional shutdowns, the system will disable the one time push of the REMOTE START If an engine fault is present or fuel level is low, the button for two seconds after receiving a valid Remote vehicle will start and then shut down in 10 seconds. Start request. The park lamps will turn on and remain on during To Exit Remote Start Mode And Drive The Vehicle Remote Start mode. Before the end of 15-minute cycle, push and release the For security, power window and power sunroof op- UNLOCK button on the RKE transmitter to unlock the eration (if equipped) are disabled when the vehicle is doors and disarm the Vehicle Security Alarm (if in the Remote Start mode. equipped). Then, prior to the end of the 15-minute cycle, The engine can be started two consecutive times (two push and release the START/STOP button (vehicles 15-minute cycles) with the RKE transmitter. However, equipped with Keyless Enter-N-Go™). the ignition must be cycled to the RUN position before NOTE: The message ЉRemote Start Active Push Start you can repeat the start sequence for a third cycle. ButtonЉ (vehicles equipped with Keyless Enter-N-Go™) will display in the instrument cluster until you push the START button. To Exit Remote Start Mode Without Driving The Vehicle Push and release the REMOTE START button one time or allow the engine to run for the entire 15-minute cycle.