2015 Chrysler 200 Owner Manual - Page 231

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 229 • The automatic braking function may only be applied if NOTE: the vehicle deceleration is not enough to avoid collid• The driver is always responsible for controlling the ing with a detected obstacle. vehicle. • The automatic braking function may not be applied • The system is provided to assist the driver and not to fast enough for obstacles that move toward the rear of substitute the driver. the vehicle from the left and/or right sides. • The driver must stay in full control of the vehicle's • The automatic braking function can be enabled/ acceleration and braking and is responsible for the disabled from the Customer-Programmable Features vehicle's movements. section of the Uconnect® System. Refer to ParkSense® System Usage Precautions for limi• ParkSense® will retain its last known configuration tations of this system and recommendations. state for the automatic braking function through ignition cycles. ParkSense® will retain the last system state (enabled or disabled) from the last ignition cycle when the ignition is The automatic braking function is intended to assist the changed to the ON/RUN position. driver in avoiding possible collisions with detected obstacles when backing up in REVERSE gear. ParkSense® can be active only when the shift lever is in REVERSE or DRIVE. If ParkSense® is enabled at one of these shift lever positions, the system will remain active 3