2015 Jeep Cherokee Owner Manual - Page 174

172 UNDERSTANDING THE FEATURES OF YOUR VEHICLE NOTE: • If either light remains on and does not flash, or there is a very fast flash rate, check for a defective outside light bulb. If an indicator fails to light when the lever is moved, it would suggest that the indicator bulb is defective. Lane Change Assist Tap the lever up or down once, without moving beyond the detent, and the turn signal (right or left) will flash three times then automatically turn off. High/Low Beam Switch Push the multifunction lever away from you to switch • A "Turn Signal On" message will appear in the EVIC/ the headlights to high beam. Pull the multifunction lever DID and a continuous chime will sound if the vehicle toward you to switch the headlights back to low beam. is driven more than 1 mile (1.6 km) with either turn Flash-To-Pass signal on. • When the Daytime Running Lights are on and a turn You can signal another vehicle with your headlights by signal is activated, the Daytime Running Lamp will lightly pulling the multifunction lever toward you. This turn off on the side of the vehicle in which the turn will turn on the high beams headlights until the lever is signal is flashing. The Daytime Running Lamp will released. turn back on when the turn signal is turned off. Front Map/Reading Lights The front map/reading lights are mounted in the overhead console. Each light can be turned on by pressing a