2015 Jeep Cherokee Owner Manual - Page 296

294 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Firmly push and release the "LEARN" or "TRAIN- Reprogramming A Single HomeLink® Button ING" button. On some garage door openers/devices To reprogram a channel that has been previously trained, there may be a light that blinks when the garage door follow these steps: opener/device is in the LEARN/TRAIN mode. 1. Turn the ignition switch to the ON/RUN position. NOTE: You have 30 seconds in which to initiate the next 2. Push and hold the desired HomeLink® button until step after the LEARN button has been pushed. the indicator light begins to flash after 20 seconds. Do 6. Return to the vehicle and push the programmed not release the button. HomeLink® button twice (holding the button for two seconds each time). If the garage door opener/device 3. Without releasing the button proceed with "Programming A Rolling Code" step 2 and follow all remaining activates, programming is complete. steps. NOTE: If the garage door opener/device does not activate, push the button a third time (for two seconds) to Programming A Non-Rolling Code complete the training. For programming Garage Door Openers manufactured To program the remaining two HomeLink® buttons, before 1995. repeat each step for each remaining button. DO NOT 1. Cycle the ignition to the ON/RUN position. erase the channels.