2015 Jeep Cherokee Owner Manual - Page 198

196 UNDERSTANDING THE FEATURES OF YOUR VEHICLE NOTE: To Vary The Speed Setting • If your vehicle stays at standstill for longer than two To Increase Speed seconds, then the driver will either have to press the While ACC is set, you can increase the set speed by RES (resume) button, or apply the accelerator pedal to pressing the SET + button. reengage the ACC to the existing Set Speed. The speed increment shown is dependant on the chosen • ACC cannot be resumed if there is a stationary vehicle speed unit of U.S. (mph) or Metric (km/h): in-front of your vehicle in close proximity. U.S. Speed (mph) WARNING! The Resume function should only be used if traffic and road conditions permit. Resuming a set speed that is too high or too low for prevailing traffic and road conditions could cause the vehicle to accelerate or decelerate too sharply for safe operation. Failure to follow these warnings can result in a collision and death or serious personal injury. • Pressing the SET + button once will result in a 1 mph increase in set speed. Each subsequent tap of the button results in an increase of 1 mph. • If the button is continually pressed, the set speed will continue to increase in 5 mph increments until the button is released. The increase in set speed is reflected in the EVIC.