2015 Jeep Cherokee Owner Manual - Page 294

292 UNDERSTANDING THE FEATURES OF YOUR VEHICLE Before You Begin Programming HomeLink® NOTE: Ensure your vehicle is parked outside of the garage • Erasing all channels should only be performed when before you begin programming. programming HomeLink® for the first time. Do not erase channels when programming additional buttons. For more efficient programming and accurate transmission of the radio-frequency signal it is recommended that • If you have any problems, or require assistance, please a new battery be placed in the hand-held transmitter of call toll-free 1-800-355-3515 or, on the Internet at the device that is being programmed to the HomeLink® www.HomeLink.com for information or assistance. system. Programming A Rolling Code Erase all channels before you begin programming. To erase the channels place the ignition in the ON/RUN For programming garage door openers that were manuposition and push and hold the two outside HomeLink® factured after 1995. These garage door openers can be buttons (I and III) for up 20 seconds, or until the red identified by the "LEARN" or "TRAIN" button located where the hanging antenna is attached to the garage door indicator flashes. opener. It is NOT the button that is normally used to open and close the door. The name and color of the button may vary by manufacturer.