2015 Jeep Cherokee Owner Manual - Page 299

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 297 NOTE: 3. Without releasing the button proceed with "Canadian/Gate Operator Programming" step 2 and • If the indicator light stays on constantly, programfollow all remaining steps. ming is complete and the garage door/device should activate when the HomeLink® button is pushed. Using HomeLink® • To program the two remaining HomeLink® buttons, To operate, push and release the programmed repeat each step for each remaining button. DO NOT HomeLink® button. Activation will now occur for the erase the channels. programmed device (i.e., garage door opener, gate operaIf you unplugged the garage door opener/device for tor, security system, entry door lock, home/office lighting, etc.,). The hand-held transmitter of the device may programming, plug it back in at this time. also be used at any time. Reprogramming A Single HomeLink® Button Security To reprogram a channel that has been previously trained, It is advised to erase all channels before you sell or turn follow these steps: in your vehicle. 1. Cycle the ignition to the ON/RUN position. To do this, push and hold the two outside buttons for 20 2. Push and hold the desired HomeLink® button until seconds until the red indicator flashes. Note that all the indicator light begins to flash after 20 seconds. Do channels will be erased. Individual channels cannot be not release the button. erased. 3