2015 Kawasaki MULE PRO-FXT Owners Manual - Page 41
2015 Kawasaki MULE PRO-FXT Manual
Page 41 highlights
40 GENERAL INFORMATION When the protection mode is activated, the CVT belt check indicator light will start flashing. Avoid such hard usage to protect the drive belt and take actions to escape from such conditions. Refer to the "When Stuck" section in the HOW TO OPERATE chapter and "Belt Drive Transmission (CVT)" section in the MAINTENANCE AND ADJUSTMENT chapter. j ○This A. Red CVT Belt Check Indicator Light B. Yellow Engine Warning Indicator Light C. Red EPS Warning Indicator Light D. Red Parking Brake Indicator Light E. Red Reverse Indicator Light F. Green Neutral Indicator Light G. Red Seat-Belt Use Reminder H. Red Coolant Temperature Warning Indicator Light I. Red Oil Pressure Warning Indicator Light NOTE indicator light will go on when the ignition switch is turned on and go off in three seconds. Yellow Engine Warning Indicator Light: The engine warning indicator light goes on when engine parts fail to function properly. If this light goes on, have your authorized Kawasaki dealer to check the vehicle for the problem. Red EPS Warning Indicator Light: The EPS warning indicator light will momentarily illuminate when the engine starts, then go off in a second if the system is in order. If this warning indicator light illuminates any other time, it indicates the ECU or actuator has malfunctioned, or the wiring harness has become disconnected. Stop driving immediately and contact an authorized Kawasaki dealer to have the system checked. Red CVT Belt Check Indicator Light: This vehicle is equipped with a drive belt protection system that protects the drive belt from wear/tear and damage from excessive load caused by hard usage such as engine revving up while the wheels are stuck and unable to turn or exceeding maximum vehicle loads. ○The KAF820A model does not have the EPS sys- NOTE tem on it. Therefore, the EPS warning indicator