2013 Lincoln MKZ Owner Manual Printing 2 - Page 279
2013 Lincoln MKZ Manual
Page 279 highlights
Maintenance High fluid level E158846 E158844 If the fluid level is above the MAX range of the dipstick, remove fluid to reach the hashmark level. Note: Fluid level above the MAX level may cause shift or engagement concerns or possible damage. High fluid levels can be caused by an overheating condition. If your vehicle has been operated for an extended period at high speeds, in city traffic during hot weather or pulling a trailer, the vehicle should be turned off until normal operating temperatures are reached. Depending on vehicle use, cooling times could take up to 30 minutes or longer. Adjusting Automatic Transmission Fluid Levels Before adding any fluid, make sure the correct type is used. The type of fluid used is normally indicated on the dipstick and also in the Technical Specifications section in this chapter. Note: An overfill condition of transmission fluid may cause shift or engagement concerns or possible damage. Do not use supplemental transmission fluid additives, treatments or cleaning agents. The use of these materials may affect transmission operation and result in damage to internal transmission components. Reinstall the air filter assembly. After the fluid level has been checked and adjusted as necessary, do the following: 1. Shut the engine off. 2. Loosen the clamp holding the air filter assembly to the rubber hose. 3. Rotate the air filter assembly 90 degrees clockwise without disconnecting the sensor. 4. Seat the air filter assembly back into the grommets by pushing down on the air filter assembly. 5. Tighten the clamp. 6. Install and tighten two bolts that attach air filter assembly to the front of the vehicle. 277 E158845 MKZ (CC9)