2013 Lincoln MKZ Owner Manual Printing 2 - Page 71

Locks Recalling Memory Positions The programmed entry codes will recall driver memory positions as follows Entry code 1 will recall driver 1 memory positions. Entry code 2 will recall driver 2 memory positions. Entry code 3 will recall driver 3 memory positions. • • switching the ignition on unlocking your vehicle using intelligent access. Unlocking and Locking the Doors To Unlock the Driver Door Enter the factory-set 5-digit code or your personal code. You must press each number within five seconds of each other. The interior lamps will illuminate. Note: All doors will unlock if you enable the all-door unlocking mode. See Locking and Unlocking (page 62). To Unlock All Doors Enter the factory-set code or your personal code, then press 3·4 within five seconds. To Lock All Doors Press and hold 7·8 and 9·0 at the same time (with the driver door closed). You do not need to enter the keypad code first. To Release the Trunk Enter the factory-set code or your personal code, then press 5·6 within five seconds. Displaying the Factory Set Code Note: You will need to have two programmed intelligent access keys for this procedure. To display the factory-set code in the information display: Note: Personal entry codes 4 and 5 will not recall memory positions. Erasing a Personal Code 1. Enter the factory-set 5-digit code. 2. Press and release 1·2 on the keypad within five seconds. 3. Press and hold 1·2 for two seconds. You must do this within five seconds of completing Step 2. All personal codes are now erased and only the factory-set 5-digit code will work. Anti-Scan Feature The keypad will go into an anti-scan mode if you enter the wrong code seven times (35 consecutive button presses). This mode disables the keypad for one minute and the keypad lamp will flash. The anti-scan feature will turn off after: • one minute of keypad inactivity • pressing the unlock button on the remote control 69 MKZ (CC9)