1996 Oldsmobile Aurora Owner's Manual - Page 135

.pse m m. When the ignition is on, the Driver Information Center can be used as astopwatch. The display will show hours and minutes. The elapsed time indicator will record up to 100 hours, then it will reset to zero and continue counting. Press ET, and the display will show the amount of time that has elapsed since the elapsed time indicator was last reset(not including time the ignition is off), such as: 01:08 ELAPSED TIME To reset elapsed time to zero, press RESET while the elapsed time is displayed. Notice that each key has a number. Push the key to enter the number. The first XX's will flash until you enter the first digit for the month. You don't need to enter the leading zero if the number is under 10. Press ENTER after you've entered the month. The display will change to: DAY? MM/XX/YY Set the day just as you set the month. Afterthe day entry is made, press ENTER, and the display will change to: YEAR? MM/DD/XX Set the year just as you set the month and day. a valid If date is entered, the display will automatically exit to the date mode and display theday of the week, the month and the date. If an invalid date is entered, the display will return to MONTH? XX/DD/YY and you'll needto repeat the above steps. After a battery reconnect (loss of power), the display will read CONFIRM TIME AND DATE. Press DATE to display the date. To change the date, press DATE then RESET.The following display will appear: MONTH? XX/DD/YY MM, DD and YY represent the month, date and year you currently have in your system. Check to make sure your clock is in the correct AM or PM mode. ?-79