1996 Oldsmobile Aurora Owner's Manual - Page 156
1996 Oldsmobile Aurora Manual
Page 156 highlights
RCL: Press this button briefly to recall the station'being played.or to display the clock. To change what is normally shown on the display (station or time), press the RCL buttonuntil you see the display you want, then hold the RCLbutton until the display flashes. If you press the button when the ignition is off, the clock will show for afew seconds. PSCAN: Press SCAN for more than two seconds, and PSCAN will appear on the display. The radiowill go to the firstpreset station stored on your pushbuttons, stop for a few seconds, then go on to the next preset station. Press SCANagain to stop scanning. PUSHBUTTONS: The fivenumbered pushbuttons let you return to your favorite stations. You can set upto 15 stations (five AM, five F l and five FM2). M 1. Press AM-FM to.select the band. g a Station AM-FM: Press this button to get AM, F M 1 or FM2. The display shows your selection. 2. Find the station you want by using TUNE or SEEK. 3. Press TONE to select the graph that best suits the type of station selected. 4. Press and hold one of the fivenumbered buttons. 1 TUNE: .Press this knob lightly so it extends. Turn it.to choose radiostations. Push the knob back in when you're not using it. SEEK:.l?ress the up or 'down arrow to go to the next higher or lower station. 'The sound will be muted while seeking. SCAN: Press this button and release it to listen to stations for afew seconds. The radio will go to a station, stop for a seconds, then goon to thenext station. few Press the button again to stop scanning. The sound will be muted while scanning, and SCAN will appear on the display. If you press SCAN for more than twoseconds, the radio will change to PSCAN mode. PSCAN will appear on the display. 5 . The sound will mute. When it returns, release the button. Whenever you press that numbered button, the station you set wili return and the TONE equalization that you selected will also be automatically selected for that button. Lf you manually tune or useSEEK or SCAN to find a frequency storedin a preset, the TONE equalization stored for that frequency will not recalled. Always check the be display first to make sure you have the correct band. 3-18