3Ware 9650SE-8LPML-SGL Installation Guide - Page 42
Disconnect the battery power cable from the BBU., To do so
UPC - 693494600087
View all 3Ware 9650SE-8LPML-SGL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Chapter 3. Installing the Battery Backup Unit 4 While pressing down on the top of the battery module, lift out the bottom of the battery module slightly. 5 Once the bottom of the module is free, slide the module up to release the clips on the top. Figure 32. Removing the battery module Bottom clip a) Push the battery module down gently. b) Lift out the bottom of the battery module to release the clip on the bottom edge. c) Lift up to remove the clips on the top edge. 6 Disconnect the battery power cable from the BBU. To do so, press down on the lever-like clip on the battery power connector and slide it out of the slot. (If desired, you can remove the BBU control module to facilitate disconnecting the power cable.) 38 3ware 9650SE Serial ATA RAID Controller Installation Guide