Acer Altos G710 Altos G710 User's Guide - Page 56
Appendix C: SCSI RAID configuration on SCSI HDD power cable
View all Acer Altos G710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
46 3 System upgrade (2) Locate and attach the following cables clamped on the side of the chassis to their corresponding connectors on the SCSI backplane: Important: If a four-bay hot-plug SCSI HDD cage is already installed in the top HDD bay, you must block the J1 jumper. Set pins 1 and 2 to close. (a) SCSI data cable (b) SCSI HDD power cable (c) SCSI HDD management cable (3) Tighten the four thumbscrews to secure it to the chassis. 4 Observe the post-installation instructions described on page 40. Important: When you are detaching the hot-plug cage from the chassis, make sure to first remove all hard disks from their carriers. For instructions, refer to the succeeding section. 5 Change the RAID configuration of your hard disk. For details on how to change the RAID configuration of your hard disk, go to "Appendix C: SCSI RAID configuration" on page 157.