Acer Altos G710 Altos G710 User's Guide - Page 61
Replacing storage devices, Replacing the FDD
View all Acer Altos G710 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
51 Replacing storage devices The system supports one 3.5-inch and three 5.25-inch internal storage devices. The system comes pre-installed with a floppy drive and a CD-ROM drive. The two empty 5.25-inch drive bays allow you to install additional drives such as another CD-ROM drive or a tape drive. These provide the system with additional storage capacity. Replacing the FDD 1 Observe the ESD precautions and pre-installation procedures described on page 39. 2 Disconnect the IDE and FDD cables from the old drive. 3 Press the release bracket on both sides of the drive carrier (1) before pulling it out from the chassis (2).
51
Replacing storage devices
The system supports one 3.5-inch and three 5.25-inch internal storage
devices. The system comes pre-installed with a floppy drive and a
CD-ROM drive.
The two empty 5.25-inch drive bays allow you to install
additional drives such as another CD-ROM drive or a tape drive. These
provide the system with additional storage capacity.
Replacing the FDD
1
Observe the ESD precautions and pre-installation procedures
described on page 39.
2
Disconnect the IDE and FDD cables from the old drive.
3
Press the release bracket on both sides of the drive carrier
(1)
before pulling it out from the chassis
(2)
.