Airlink AR570WV2 User Manual - Page 66

For each rule, you can define: • Source IP address • Destination IP address • Destination port address • Protocol: TCP or UDP or both. Parameters Description Outbound Packet Filter Check/uncheck Enable to enable/disable the Packet Filtering. Outbound Filter applies to all outbound packets but Inbound Filter applies only to packets that are destined to Virtual Servers or DMZ host. Allow / Deny all to pass except Please select "Allow" or "Deny" to decide the behavior of packet those that match the following rules filtering table. If you select allow, all traffic will be allowed except that the Source IP addresses listed in filtering table will be rejected to connect to the destination IP addresses and ports. If you select deny, all traffic will be denied except that the Source IP address listed in filtering table will be allowed to connect to the destination IP addresses and ports. Source IP Please input the client's IP address you wish to apply the filtering rule. You can input a single IP address (192.168.2.10) or a range of IP addresses (192.168.2.10-192.168.2.50). Leaving this field blank indicates all IP addresses. Destination IP Please input the Destination IP address (i.e. an FTP site, Email server, etc.) you wish to apply the filtering. You can input a single IP address (192.168.2.10) or a range of IP addresses (192.168.2.10-192.168.2.50), leaving this field blank means all IP addresses. Port Please input the port number here. You can define a single port (80) or a range of ports (1000-1999). Add prefix "T" or "U" to specify TCP or UDP protocol, for example, T80, U53, U2000-2999. No prefix indicates both TCP and UDP are defined. Leaving this field blank indicates all ports. Enable Check/uncheck Enable to enable/disable each Packet Filtering rule. Schedule Rule# Enter a Schedule Rule number to activate the filtering rule only within the desired time frame. Please refer to 3.4.7 Schedule 62