Asus T2-AH1 T2-AH1 English user manual E2065 - Page 78
to fit these connectors in only one orientation. Find the proper
View all Asus T2-AH1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
5 . ATX power connectors (24-pin EATXPWR, 4-pin ATX12V) These connectors are for the 24-pin and 4-pin power plugs from the power supply unit. The plugs from the power supply unit are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit. ATX power connectors ® ATX12V GND GND EATXPWR +12V DC +12V DC +3 Volts Ground +12 Volts +5 Volts +12 Volts +5 Volts +5V Standby +5 Volts Power OK -5 Volts Ground Ground +5 Volts Ground Ground Ground +5 Volts PSON# Ground Ground +3 Volts -12 Volts +3 Volts +3 Volts Do not forget to connect the 4-pin ATX12V power plug to the ATX12V connector on the motherboard; otherwise, the system will not boot up. 6 . Floppy disk drive connector (34-1 pin FLOPPY) This connector is for the provided floppy disk drive (FDD) signal cable. Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive. Pin 5 on the connector is removed to prevent incorrect cable connection when using an FDD cable with a covered Pin 5. ® Floppy disk drive connector FLOPPY NOTE: Orient the red markings on the floppy ribbon cable to PIN 1. PIN 1 4-6 Chapter 4: Motherboard info