Autodesk 00128-051462-9310 User Guide - Page 2204

Jig Option Comment Boolean value specifying whether the common command line options of the Jig are valid options for this Recipe. The following table lists the JigEnt options for Bookends Jigs JigEnt Option Comment Boolean value specifying whether items along the line are oriented in the X direction or the Y direction. Specifies the exact width of the Block Reference at the beginning of the array. If you do not know this value and leave this element out, the extents of the block will be dynamically measured. If you know this value, you should specify it, because measuring the extents dynamically can sometimes introduce rounding errors that can affect the overall dimensions of the array. Same as above, but for the ending block of the array. Same as above, but for the repeating block of the array The distance between each arrayed item. To use this Jig directly from a common recipe function, use the following section of RecipeSpec. AecRcpBase40 Bookends When using this function, you can also specify an directive that will allow you to package all the individual blocks in the array into a single block reference. By default, this value is set to "false" and each item in the array will be its own block reference. true Surface Jig This Jig creates a basic rectangular boundary of a given depth, where the user is asked for an arbitrary start and endpoint (similar to adding Walls in AutoCAD Architecture). Here is an example usage: Start point End point true true In each case, the value listed is the default and would be used if nothing was specified. To use this Jig directly from a common recipe function, use the following section of RecipeSpec. AecRcpBase40 Surface StampMInsert Jig The StampMInsert Jig is the same as the Stamp Jig, except that it uses an MInsert instead of a simple Block Reference. 2164 | Chapter 52 Customizing and Adding New Content for Detail Components