Brother International BAS-300 Series Programmer Instruction Manual - English - Page 12
Pattern
View all Brother International BAS-300 Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Ij To program an intermittent stitch sewing operation • After the thread trimming operation is completed, if the sewing operation is to be continued without lifting the work clamp, use the Ej key (Feed key) to facilitate the programming operation. (X-0, Y-O) Example: Program the pattern in the figure at left. (1) Press the ['key. The work clamp will move to the point of origin (X-0; Y-0), the numeral "0" will be indicated on the STEP display, and the command indicator "F" will illuminate. (2) Operate the direction keys to move the work clamp to the initial stitch position. (3) When the tip of the needle and the initial stitch position 0 on the outline of the needle movement become aligned, press the 0 key. Thus, the initial stitch will be programmed. (4) Repeat the above procedure to program the remaining stitches of pattern 1. (5) Press the O key at the final stitch position® of pattern EJ • 1, and then press the Ei key. At this time, the command indicator "F" will illuminate. Pattern 1 (=> Feed key Pattern 1 Pattern 2 I -111 • (6) Operate the direction keys to move the work clamp to the initial stitch position of pattern 2. (7) When the tip of the needle and the initial stitch position © of pattern 2 become aligned, press the key. Thus, the operation will be programmed to restart from point © after the thread trimming operation is completed at point 0. (8) Repeat the above procedure to program the remaining stitches of pattern 2. (9) Press the key at the final stitch position ©, and press the numeral key 111 3 times to indicate "111" on the STEP display. Then, press the LJ key. (10) The work clamp will move back to the initial stitch position. (11) Press the R/W switch to write the pattern to disk. (Refer to page 24.) Press the 0 key to enter the sewing mode. Pattern 2