Brother International BAS-300 Series Programmer Instruction Manual - English - Page 18
Split, sewing, without, intermediate, thread, trimming
View all Brother International BAS-300 Series manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
E Split sewing without intermediate thread trimming • This unit was designed to cut the thread at the division in split sewing. However, continuous sewing of split patterns and garments in which intermediate thread trimming is undesirable is now possible with the new program for full circumference sewing using special work clamps (inner clamps). I • 0 11 0 888 El • © 0 O Inner clamp 0 EA) Amount of one stitch length Work clamp Example: Sewing with a special purpose work clamp (inner clamp). [programmed method] (1) Set the power source switch to the ON position. (2) Press the E] key. The work clamp will move to the point of origin (X-0; Y-0), "0" will be indicated in the X, Y, and STEP display and the command indicator "F" will illuminate. (3) Use the feed key and program from 0 to 0. (4) At position ®, use the numeral key 3 times to indicate "888" on the STEP'display, and then press the key. (5) Use the feed key and move the needle tip to position ®. The distance from position ® to ® is one stitch length. (6) Program from position ® to (D. Press the El key to enter the sewing mode. (Operation) 0 Set the work piece as shown in the figure above, and press the starting pedal. 0The sewing machine will sew from 0 to ®, the thread will be cut at ®, the needle will rise, and the machine will stop. Remove the work clamp (inner clamp), and press the starting pedal again. 0 The sewing machine will sew from ® to 0. ®