Brother International Innov-ís 2800D Users Manual - English - Page 26

LOWER/UPPER THREADING LOWER/UPPER THREADING Winding the Bobbin This section describes how to wind thread onto a bobbin. With this machine, you can use the supplemental spool pin to wind the bobbin while sewing using the main spool pin. c Set the supplemental spool pin in the "up" position. a CAUTION • The included bobbin was designed specifically for this sewing machine. If bobbins from other models are used, the machine will not operate correctly. Use only the included bobbin or bobbins of the same type (part code: X52800-150). 11.5 mm (approx. 7/16 inch) Actual size This model Other models a Supplemental spool pin d Place the spool of thread on the supplemental spool pin so that the thread unwinds from the front. Then, slide the spool cap as far as possible onto the supplemental spool pin to secure the thread spool. ■ Using the Supplemental Spool Pin While sewing embroidery, the bobbin can conveniently be wound. 65 a 3, 4 2 7, 8 9,10 l o 1 a Supplemental spool pin a Turn on the machine, and then open the top cover. b Align the groove in the bobbin with the spring on the bobbin winder shaft, and then set the bobbin on the shaft. a b a b c a Supplemental spool pin b Spool cap c Thread spool CAUTION • If the thread spool and/or spool cap are set incorrectly, the thread may tangle on the spool pin and cause the needle to break. • Use the spool cap (large, medium, or small) that is closest in size to the thread spool. If a spool cap smaller than the thread spool is used, the thread may become caught in the slit on the end of the spool. a Groove in bobbin b Spring on bobbin winder shaft 24