Brother International Innov-ís 2800D Users Manual - English - Page 54

SELECTING A UTILITY STITCH c Press to go back to the original screen. c Press . * To reset the selected stitch pattern to its default settings, press , and then press . Saving Stitch Settings This machine is preset with the default settings for the stitch width (zigzag width), stitch length, thread tension, automatic thread cutting, automatic reverse/ reinforcement stitching, etc. However, if you wish to save specific settings for a stitch so that they can be used later, press after changing the settings to save the new settings with the selected stitch. Example: Using a stitch length of 2.0 mm for the straight stitch a Select a straight stitch. Memo The default stitch length is 2.5 mm. b Set the stitch length to 2.0 mm. → The confirmation message appears. d Press . Memo • The next time that the same straight stitch is selected, the stitch length is set to 2.0 mm. • All stitch settings (stitch width (zigzag width), stitch length, thread tension, automatic thread cutting, and automatic reverse/reinforcement stitching) are saved, not just the setting that was changed. When the same stitch pattern is selected, the last settings saved are displayed even if the machine was turned off. If the settings are changed again and is pressed, or if is pressed to reset the setting to its default, the new settings are not saved unless is pressed another time. • Even if is pressed, the settings for automatic thread cutting and automatic reverse/reinforcement stitch cannot be reset. 52