Brother International Innov-is 1000 Operation Manual - Page 173
Error Message, Probable Cause
View all Brother International Innov-is 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 173 highlights
APPENDIX Error Message Probable Cause The start/stop button was pressed while the foot controller was connected. You tried to use the foot controller for embroidery. A stitch other than the buttonhole, bar tack or darning stitch was selected and the start/stop button was pressed while the buttonhole lever is lowered. The buttonhole, bar tack or darning stitch was selected and the start/ stop button was pressed while the buttonhole lever is raised. You tried to set a number of characters that will not fit within the frame. The start/stop button or reverse/reinforcement stitch button was pressed when no pattern is selected. The twin needle setting is selected while a pattern that cannot be sewn with the twin needle is selected. The start/stop button was pressed without connecting the foot controller while the setting for adjusting the stitch width using the sewing speed controller is set to [ON]. You have selected a pattern for which width control cannot be used. You pressed the back key or the utility stitch key or the embroidery key while a pattern was selected. Bobbin thread has run out. Little bobbin thread remains. The reverse/reinforcement stitch button, needle position button or thread cutter button was pressed while the bobbin winder shaft is moved to the right. A twin needle was set up with a pattern where a twin needle cannot be selected. A pattern is being stored. The bobbin winder is winding the bobbin. When the embroidery unit is attached. 172