Brother International Innov-is 1000 Operation Manual - Page 93
toward you counterclockwise to check
View all Brother International Innov-is 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
UTILITY STITCHES Select stitch 3 . h When you are about 5 cm (2 inches) from the j end of the zipper, stop the sewing machine with the needle lowered (in the fabric), raise the presser foot lever. Open the zipper and continue sewing. k • For details, refer to "Selecting stitching" (page 49). CAUTION ● When using zipper foot "I", be sure to select the straight stitch (center needle position), and slowly turn the handwheel toward you (counterclockwise) to check that the needle does not touch the presser foot. If a different stitch is selected or the needle hits the presser foot, the needle may bend or break. Sew the zipper to the piece of fabric with the i extra 3 mm (1/8 inch), starting from the base of the zipper. Close the zipper, turn over the fabric, and then l baste the other side of the zipper to the fabric. 1 CAUTION ● When sewing, be sure that the needle does not touch the zipper, otherwise the needle may bend or break. a Basting stitching Attach the presser foot holder to the other pin m of zipper foot "I". If the presser foot holder was attached to the right pin in step g, change it to the left pin. 1 I 2 a Pin on the left side b Needle drop point 92