Brother International Innov-is 1000 Operation Manual - Page 27
thread using the cutter built into the slit
View all Brother International Innov-is 1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
GETTING READY Pass the end of the thread through the guide l slit in the bobbin winder seat, and then pull the thread to the right to cut it. • When the bobbin winding becomes slow, press (Start/stop button) once to stop the machine. 1 a Guide slit in bobbin winder seat (with built-in cutter) CAUTION ● Be sure to cut the thread as described. If the bobbin is wound without cutting the thread using the cutter built into the slit in the bobbin winder seat, the thread may become tangled in the bobbin or the needle may bend or break when the bobbin thread starts to run out. Slide the sewing speed controller to the right. m CAUTION ● When the bobbin winding becomes slow, stop the machine, otherwise the sewing machine may be damaged. Use scissors to cut the end of the thread o wound around the bobbin. Slide the bobbin winder shaft to the left, and p then remove the bobbin from the shaft. 1 a Speed controller Press (Start/stop button) once to start n winding the bobbin. Remove the spool for the bobbin thread from q the spool pin, and then close the top cover. Memo z When the sewing machine is started or the handwheel is turned after winding the bobbin, the machine will make a clicking sound; this is not a malfunction. 1 a Start/stop button 26