Brother International Innov-is NS80e Operation Manual - Page 25
Sewing Basics
![]() |
View all Brother International Innov-is NS80e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Sewing 2 Chapter SEWING BASICS Sewing CAUTION • While the machine is in operation, pay special attention to the needle location. In addition, keep your hands away from all moving parts such as the needle and handwheel, otherwise injuries may occur. • Do not pull or push the fabric too hard while sewing, otherwise injuries may occur or the needle may break. • Never use bent needles. Bent needles can easily break, possibly resulting in injuries. • Make sure that the needle does not strike basting pins, otherwise the needle may break or bend. Basic sewing Note • First, perform a trial sewing, using a piece of fabric and thread that are the same as those used for your project. Prepare the appropriate needle and thread for the type a of fabric. (page 19) If necessary, replace the needle. (page 20) Wind thread onto a bobbin, and then install it into the b machine. (page 12) Thread the upper thread. (page 15) c Turn the stitch pattern selection dial to select a stitch. d The position where the stitch number is shown differs depending on the model. SEWING BASICS 2 • For details on the built-in stitch patterns, refer to "Stitch Chart" on page 33. • If necessary, change the stitch width or stitch length. (page 27) • For details on the LCD viewing, refer to "LCD Operation" on page 10. 23
![](/manual_guide/products/brother-international-innovis-ns80e-operation-manual-cb10c75/25.png)