Brother International Innov-is NS80e Operation Manual - Page 35

3 Chapter VARIOUS STITCHES Stitch Chart Stitch Chart ■ Utility stitches Memo • When any of the following stitches (reverse stitch patterns and reinforcement stitch patterns) are selected, pressing (Reverse stitch button) will sew reverse stitches. Stitch 80 stitches 60 stitches No. 50 stitches 16 stitches 01 02 03 04 07 08 09 10 15 16 18 01 02 03 04 07 08 - 09 14 - 16 01 02 03 04 07 08 - 09 14 - 16 01 - 02 - 04 - - 09 - - - When any other stitch is selected, pressing (Reverse stitch button) will sew reinforcement stitches. • The stitch pattern symbols indicate the following. a bd c de 1 Left needle position e 2 Middle (center) needle position 3 Right needle position 4 Reverse stitch pattern 5 Reinforcement stitch pattern VARIOUS STITCHES 3 Note • The walking foot can only be used with straight or zigzag stitch patterns. Do not sew reverse stitches with the walking foot. *1 Twin needle can be used by attaching zigzag foot "J". (page 33 to 36) *2 When using the twin needle, set the stitch width between 1.0 mm (1/16 inch) and 6.0 mm (15/64 inch). *3 When using the twin needle, set the stitch width of 5.0 mm (3/16 inch) or less. No. Stitch Presser foot Stitch name/Applications Stitch width (mm (inch)) Auto. Manual Stitch length (mm (inch)) Auto. Manual 80 stitches model 60 stitches model 50 stitches model 16 stitches model 01*1 01*1 01*1 01 02*1 02*1 02*1 - 03*1 03*1 03*1 02*1*2 04*1 04*1 04*1 - 05*1 05*1 05*1 10 Straight stitch (Left) J General sewing, gather, pintuck, etc. Straight stitch (Left) J General sewing, gather, pintuck, etc. Straight stitch (Middle) J General sewing, gather, pintuck, etc. Straight stitch (Middle) J General sewing, gather, pintuck, etc. Triple stretch stitch J General sewing for reinforcement and decorative topstitching 0.0 (0) 0.0 - 7.0 (0 - 1/4) 0.0 (0) 0.0 - 7.0 (0 - 1/4) 3.5 (1/8) 0.0 - 7.0 (0 - 1/4) 3.5 (1/8) 0.0 - 7.0 (0 - 1/4) 0.0 (0) 0.0 - 7.0 (0 - 1/4) 2.5 (3/32) 0.2 - 5.0 (1/64 - 3/16) 2.5 (3/32) 0.2 - 5.0 (1/64 - 3/16) 2.5 (3/32) 0.2 - 5.0 (1/64 - 3/16) 2.5 (3/32) 0.2 - 5.0 (1/64 - 3/16) 2.5 (3/32) 0.4 - 4.0 (1/64 - 3/16) 33