Brother International Innov-is NS80e Operation Manual - Page 63
If the thread becomes tangled under the, bobbin winder seat, List of symptoms
View all Brother International Innov-is NS80e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Troubleshooting If the thread becomes tangled under the bobbin winder seat If the bobbin winding starts when the thread is not passed under the pretension disk of the bobbin-winding thread guide correctly, the thread may become tangled under the bobbin winder seat. CAUTION • Do not remove the bobbin winder seat even if the thread become tangled under the bobbin winder seat. Otherwise, the cutter in the bobbin winder seat may be damaged. • Do not remove the screw on the bobbin winder guide post, otherwise the machine may be damaged; you cannot wind off the thread by removing the screw. a 1 Screw of the bobbin winder guide post Stop the bobbin winding. a Cut the thread with scissors beside the bobbin-winding b thread guide. Slide the bobbin winder shaft to the left, and then c remove the bobbin from the shaft and cut the thread leading to the bobbin in order to be able to completely remove the bobbin from shaft. Hold the thread end with your left hand, and wind off d the thread clockwise from under the bobbin winder seat with your right hand as shown below. List of symptoms Check the following possible problems before requesting service. If the reference page is "*", contact your authorized Brother dealer or the nearest Brother authorized service center. ■ Getting ready Symptom, Cause/solution Reference Cannot thread the needle. Needle is not in the correct position. 6 • Press the "Needle position" button to raise the needle. Needle is installed incorrectly. 20 Needle is turned, bent or the point is dull. 20 Upper threading is incorrect. 15 The needle threader lever is not lowered until it clicks. The needle threader hook is bent and does not * pass through the eye of the needle. The needle threader lever cannot be moved or * returned to its original position. A size 65/9 needle is being used. 17 • The needle is incompatible with the needle threader. Manually pass the thread through the eye of the needle. Bobbin thread does not wind neatly on the bobbin. The thread is not passed through the bobbin 12 winding thread guide correctly. The thread that was pulled out from the bobbin- 13 winding thread guide was incorrectly wound onto the bobbin. The empty bobbin was not set on the pin 12 properly. While winding the bobbin, the bobbin thread was wound below the bobbin winder seat. The thread was incorrectly passed under the pretension disk on the bobbin-winding thread guide. • Remove any entangled thread, and then wind the bobbin. 12, 61 The bobbin thread cannot be pulled up. Needle is turned, bent or the point is dull. 20 Bobbin is set incorrectly. 14 Nothing appears in the LCD. Main power switch is not turned on. 9 The plug of the power cord is not inserted into an 9 electrical outlet. APPENDIX 4 61