Brother International Innov-is NS80e Operation Manual - Page 52
Fagoting, Scallop stitching, Smocking
View all Brother International Innov-is NS80e manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
Utility stitches After sewing is finished, raise the presser foot lever, g remove the fabric, and then cut the threads. Raise the buttonhole lever to its original position. h ■ Fagoting Stitching across an open seam is called "fagoting". It is used on blouses and children's clothing. This stitch is more decorative when thicker thread is used. Use an iron to fold the two pieces of fabric along their a seams. Baste the two pieces of fabric, separated by about 4 b mm (3/16 inch), onto thin paper or a sheet of water soluble stabilizer. If you draw a line down the middle of the thin paper, or water soluble stabilizer, sewing is easier. 1 Thin paper or water 3 soluble stabilizer 2 Basting stitching 1 3 4 mm (3/16 inch) 2 ■ Scallop stitching The wave-shaped repeated stitch pattern that looks like shells is called "scalloping". It is used on the collars of blouses and to decorate the edges of projects. Attach monogramming foot "N". a Select a stitch. b No. Stitch 8 0 stitches 6 0 stitches 5 0 stitches 1 6 stitches 26 24 23 - • For details, refer to "Stitch Chart" on page 33. Stitch along the edge of the fabric, making sure not to c sew directly on the edge of the fabric. Attach zigzag foot "J". c Select a stitch. d No. Stitch Trim along the stitches. d 8 0 stitches 6 0 stitches 5 0 stitches 1 6 stitches 31 29 28 12 32 30 29 - • For details, refer to "Stitch Chart" on page 33. Set the stitch width to 7.0 mm (1/4 inch). e Sew with the center of the presser foot aligned along f the center of the two pieces of fabric. After sewing is finished, remove the paper. g • Be careful not to cut the stitches. ■ Smocking The decorative stitch created by stitching or embroidering over gathers is called "smocking". It is used to decorate the front of blouses or cuffs. The smocking stitch adds texture and elasticity to fabric. Attach zigzag foot "J". a Select the straight stitch, and then adjust the stitch b length to 4.0 mm (3/16 inch) and loosen the thread tension. Sew parallel stitching at intervals of 1 cm (3/8 inch) c and pull the bobbin threads to create gathers. Smooth the gathers by ironing them. 50