Canon CONSOLE Image Control & Storage Software v1.1 Console Software Operation - Page 31

CONSOLE Windows [Option settings] and [Performance check] Camera and Picture Control Recording onto the Hard Disk Playback the Recorded Files 4-11 Camera and Picture Control 2 [Line Select] You can select the image-scanning mode of the waveform monitor and the vector scope. 1 2 3 1 Switches over between the line and full scan mode. 2 Displays the selected line number. 3 Selects a number of lines used in the line mode. A line on the preview will be displayed in the line mode. You can drag up/down the line with the mouse to select a scan line. A line for scanning 3 [Display] You can display and hide the waveform monitor and the vector scope. 4 Waveform monitor A waveform of the preview picture is displayed. 5 Scale You can select the scale of the waveform monitor. [RE]: [Volt 1]: [Volt 2]: -40 IRE - +140 IRE -0.3V - +1.0V 0V - +1.3V 6 [Wave Mode] You can select the display mode of the waveform monitor. In the PARADE mode, the waveform monitor will be tri-partitioned. [Composite]: Displays a luminance and color-difference signal [Y]: Displays the luminance signal [YUV]: Displays the luminance signal, the blue differential signal, and the red differential signal in PARADE mode. [RGB]: Displays RGB signals in the PARADE mode in the R, G, B order. 7 Vector scope Displays the color information of [Rec Viewer]. Depending on the recording standards, the panel changes automatically. [Custom Preset] You can adjust and save the Custom Preset settings. For details, refer to the camcorder instruction manual.  Depending on the camcorder connected, some parameters differ. For details, refer to the camcorder instruction manual.  The [Custom Preset] window cannot be used when recording.  When using XL2, you need to set the camcorder's recording program to EXT.CONT.  When using XL H1, you need to set the camcorder's recording program to EXT.CONT. to import and export the Custom Preset files. When using XL H1, CONSOLE will reset the Custom Preset settings in the following cases. Save the Custom Preset file on the camcorder memory or memory card, and apply it to the camcorder. - Changing the camcorder mode from Camera mode to other mode - Disconnecting the IEEE 1394 (DV) cable - Changing the position of the TAPE/CARD switch - Follow the procedure below to save the Custom Preset file on the Camcorder's memory or memory card. 1. Save the Custom Preset file onto the hard disc. ( 4-13) 2. Set the Camcorder mode to EXT.CONT. 3. Load the Custom Preset file (saved on the hard disc) to the Camcorder's memory. ( 4-12) 4. Save the Custom Preset file on the Camcorder's memory or memory card. ( 4-13)  You can change the setting using the keyboard. - You can select the next item with the [] or [Tab] key, and go back to the previous item with the [] or [Shift] + [Tab] keys. You can also select items by pressing [2] (down), [4] (left), [6] (right), and [8] (up) keys. - The parameters can be changed with the [] and [] keys.