Canon EOS R5 C Advanced User Guide VIDEO edition - Page 100

Synchronizing with an External Device Synchronizing with an External Device You can use the camera's TIME CODE terminal to synchronize this camera's time code to an external signal. Using the same external time code signal with multiple cameras allows you to set up a multi-camera recording. 100 You can also output the time code signal from this camera to other cameras. Connecting an External Device When synchronizing a time code signal, connect the external device to the TIME CODE terminal on the camera. Be sure to set the TIME CODE terminal to input or output in advance. Connection diagram TIME CODE terminal Standard TC signal DIN-BNC cable (commercially available) IMPORTANT Commercially available DIN-BNC cables and the TIME CODE terminal There are DIN cables with a long release mechanism (Fig. 1-A), and cables with a short release mechanism (Fig. 1-B). If you connect a cable with a short release mechanism to the TIME CODE terminal, it may not be possible to disconnect it from the camera (Fig. 2). Use a cable with a release mechanism long enough to allow you to grip it and pull to release even when it is connected to the camera. Cable tested for use with this camera: Canare D2.5HDC***E-D ("***" indicates length) For the latest information about DIN cables tested for use with this camera, visit your local Canon website. Fig. 1 Fig. 2 A B Release mechanism Time Code Signal Input An external SMPTE-standard LTC timing signal received from the TIME CODE terminal can be recorded as the time code. The user bit of the external timing signal can also be recorded with clips. Before connecting the device, set the TIME CODE terminal to input with the procedure below and make sure the time code running mode is set to [Free Run] (A 98).