Canon EOS R5 C Advanced User Guide VIDEO edition - Page 161

Configuring Connection Settings Adding a New Connection Setting Using the Wizard You can use the wizard to set up a new connection setting. This section uses a connection to a Wi-Fi network using the WPS push button method as an example. Refer to the instruction manual of the access point for details about the location and operation of the WPS button. 1 Enable the network functions (A 160). 2 Select [OK]. > [ Network Settings] > [New Conn. Setting (Wizard)] > Desired network function > 3 Select [Create New Comm. Setting]. • Once you have added multiple communication settings, you can select [Select Existing Setting] to reuse the settings for a network that you saved previously. 4 Select [Wi-Fi ]. • To configure a wired (Ethernet) network (A 165). 5 Select [Connect with WPS] > [WPS (Push Button)]. • To use a different configuration method, complete the corresponding procedure. Camera Access Point (A 165) WPS using a PIN code (A 166) Detected access points (A 166) SSID/authentication mode input (A 167) Manual setup without connecting to the network (A 167) 6 Press and hold the WPS button on the wireless router and then, on the camera, select [OK]. 7 To configure the IPv4 settings automatically and not use IPv6 settings, select [Automatic Setting] > [Disable]. • To configure IPv4 settings manually (A 167). • To use the default IPv6 settings, select [Enable] instead. After completing the wizard, change the IPv6 settings as necessary (A 171). 8 Select [OK] to continue to configure the function settings. • The communication settings are saved to an [NW] file. • Continue with one the following procedures to configure the selected function's settings. FTP transfer (A 162), IP streaming (A 163), Browser Remote (A 164), Canon App (A 164) 161 NOTES • The [WPS (Push Button)] method may not work correctly depending on the devices used or the surrounding conditions. In such case try using [WPS (PIN Code)] (A 166) or selecting one of the detected networks (A 166).