Canon Microfilm Scanner 350II MS-350II Instruction Manual. 3.01 MB - Page 24
Connecting via SCSI, SCSI card, SCSI cable
![]() |
View all Canon Microfilm Scanner 350II manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
■ BEFORE YOU BEGIN ... ■ ■ Connecting via SCSI When connecting the scanner to a computer using a SCSI card, use the following SCSI cards and cables. • SCSI card Use one of the following recommended SCSI cards: Adaptec SCSI card (for PCI bus) • AHA-2930U • AHA-2940AU • ASC-19160 • ASC-29160 When installing a SCSI card on your computer, follow the directions in both the manual for the SCSI card and the computer. • SCSI cable • The SCSI connector on the scanner is a half-pitch 50-pin connector (pin-type). No SCSI cable is supplied with the scanner. To connect the scanner to a computer, obtain a SCSI cable with the correct connectors for the scanner and the SCSI card installed in the computer. • The maximum length of SCSI cables are defined by the SCSI standard. For details, see the user manual for your SCSI card. • Only one SCSI port can be used on the scanner and terminator setting is fixed to ON. You cannot daisy chain multiple MS350II scanners. • The SCSI ID for the scanner can be set from ID0 to ID5. By default, the SCSI ID for the scanner is set to SCSI ID=2. When changing the SCSI ID setting, make sure to contact an authorized Canon dealer or service professional. • When daisy chaining the scanner with the other SCSI devices, note the following: • Change the ID of the other SCSI devices so they do not to overlap. • Make sure that the scanner is at the end of the chain and the terminate setting of the other devices is OFF. 22 CE-IE-335-01 22 07.5.14, 14:19
![](/manual_guide/products/canon-microfilm-scanner-350ii-ms350ii-instruction-manual-301-mb-b84c92a/24.png)