Canon MultiPASS F50 Reference Guide for the MultiPASS F30 and MultiPASS F50 - Page 21
Printing on Banner Paper, it exits the machine.
View all Canon MultiPASS F50 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Printing on Banner Paper Banner Paper is a continuous sheet of paper with perforations at equal distances along its length, where it can be cut to the length required. For best results, use Canon Banner Paper. You can print banners from two to six sheets in length. • Always leave an extra sheet at the end of the banner-just in case the type runs over. NOTE The shaded portion of the illustration below shows the maximum recommended printing area of Banner Paper. APPROX. 66"/1676 mm (6 SHEETS MAX.) 0.25" (6.3 mm) 2 SHEETS MIN. 11" (279 mm) 0.25" (6.4 mm) 1.10" (28 mm) 8.5" (216 mm) 0.20" (5 mm) • To prevent ink from running over the edges of the sheet, print within the margins shown above. NOTE • Printing on Banner Paper may require considerable amounts of ink, so use new Ink Tanks if necessary. • For best print results on Banner Paper, use light design patterns. 1 Place the machine near the edge of a table so that the paper can flow over the edge as it exits the machine. 3 Move the paper thickness lever to the right and close the scanning unit. 2 Push the Open button and lift up the scanning unit. 3-8