Canon imagePROGRAF iPF6400 User Guide - Page 545

iPF6400 Specifying the Cutting Method for Rolls • Automatic and Eject are valid only when you have selected Auto Cut > Yes in the printer driver. Note • With Eject, printing does not resume after a series of jobs have been printed continuously until the roll is cut. • Eject is the preset selection in Cutting Mode for some types of paper. For this paper, we recommend keeping the preset cutting mode. • If documents printed using Automatic, Eject, or manual cutting are short, rolls are advanced a specific amount before cutting to prevent problems with cutting and paper ejection. This may create a wider bottom margin, in some cases. Cut rolls manually in the following cases: Eject (when the paper surface is being scratched / to wait for ink to dry) Handling and Use of Paper Handling rolls • When cutting wide printed documents after ejection, have two people support the documents. If the paper drops, printed Important documents may be damaged. • Do not lift the paper when holding printed documents before cutting. If the paper rises, it may affect the printing quality or cause rough cut edges. 1 On the Tab Selection screen of the Control Panel, press ◀ or ▶ to se- lect the Paper tab ( ). • If the Tab Selection screen is not displayed, press the Menu button. Note 2 Press the OK button. The Paper Menu is displayed. 3 Press ▲ or ▼ to select Paper Details, and then press the OK button. 4 Press ▲ or ▼ to select the type of paper, and then press the OK button. 5 Press ▲ or ▼ to select Cutting Mode, and then press the OK button. 6 Press ▲ or ▼ to select Eject, and then press the OK button. 545 7 Print the job. When printing is finished, the printer will stop without cutting. User's Guide